R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Hood Sensor/Switch (For Alarm): Service and Repair
Front Hood Switch
Removing
Proceed as follows:
‹› When installing, position cable ties in same place.
-
Remove the engine compartment lid lock => [ Engine Compartment Lid Lock ] See: Trunk / Liftgate/Trunk / Liftgate Latch/Service and
Repair/Engine Compartment Lid Lock.
-
Disconnect the cable ties - 3 -.
-
Release the retaining clamp - 1 - in the - direction of the arrow - and remove it downward.
-
Remove the front hood contact switch (F266) - item 2 - from the lid lock.
Installing
Installation is reverse of removal, but note the following:
-
Install the engine compartment lid lock => [ Engine Compartment Lid Lock ] See: Trunk / Liftgate/Trunk / Liftgate Latch/Service and
Repair/Engine Compartment Lid Lock.