R8 Quattro Coupe V10-5.2L (BUJ) (2010)
/Page-2312005.png)
-
Free up the upper side of the rear window.
-
Position the reel device (V.A.G 1654A) as shown in the illustration and free the rear window up completely.
-
Remove the rear window from the window opening using the suction lifter (V.A.G 1344).
Damaged rear window, removing
-
Protect the body and engine compartment from glass splinters.
-
Remove glass pieces from adhesive material.
-
Bond flange all around with fabric reinforced adhesive tape.
-
Cut through the adhesive sealing material (with the remainder of the glass) in the window opening using the electric cutter (V.A.G 1561A) and
angled blade (V.A.G 1561/10) (with stopper roller).
Preparations for installing rear window
-
When reusing an undamaged rear window, cut remaining adhesive sealing material on window and flange using a carpet knife so that it is even,
but do not remove completely!
‹› Residual material acts as a base for the new adhesive sealing material.
CAUTION!
‹› Keep adhesive surface free of dirt and grease.
‹› Only cut back adhesive surface shortly before installation.
