R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Cowl Moulding / Trim: Service and Repair
Cowl Panel Trim
Cowl Panel Trim
Removing
Proceed as follows:
-
Remove the bumper cover trim => [ Bumper Cover Trim ] .
-
Remove the left and right headlamp and wheel housing liner trim => [ Headlamp and Wheel Housing Liner Trim ] See: Fender/Front Fender/Front
Fender Liner/Service and Repair/Headlamp and Wheel Housing Liner Trim.
-
Remove wiper arms
-
Loosen the quick-release bolts - 1 -.
CAUTION!
There is a risk of damaging the cowl panel trim.
‹› Coat the transition between the windshield and cowl panel trim with soapy water and remove the cowl panel trim - 4 - upward
vertically - A arrows - out of the retaining strip beginning at the edge of the windshield.
-
Remove the cowl panel trim - 4 - by pulling it carefully upward out of the retaining strip - A arrows -.
-
Disengage the bottom of the front lid gas-filled struts - 2 - and - 3 -.
-
To do that, raise the retaining spring - 2 - with a small screwdriver - 1 - - arrow - and remove the gas-filled strut - 3 - from the ball stud.