R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Dashboard / Instrument Panel: Service and Repair
Central Tube Angled Bracket
Central Tube Angled Bracket
Removal
-
Remove the central tube. Refer to => [ Central Tube ]. See: Central Tube
CAUTION!
Mark the height and side position on the angle bracket for reinstallation.
-
Remove bolts - A through - and the angle bracket.
‹› The illustration shows the central tube angle bracket on the driver side.
Installation
Installation is reverse of removal, but note the following:
-
Align the central tube angle bracket according to the markings made on the A-pillar during removal.
-
Tighten the angle bracket bolts in the following sequence:
‹› Driver side: - A, B, C -.
‹› Front passenger side: - C, B, A -.
Tightening specifications, refer to=> [ Central Tube Assembly Overview ] See: Central Tube Assembly Overview.