R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Follow the safety precautions for the rollover protection. Refer to => [ Rollover Protection Additional Safety Precautions ] See: Service
Precautions.
Installation is reverse of removal, but note the following:
-
Press on the rollover protection guide back on until it engages audibly.
-
Return a deployed rollover protection back into it stored position. Refer to => [ Deployed Rollover Protection, Returning to Stored Position ] See:
Procedures.
CAUTION!
Make sure no one is standing near the rollover protection when reconnecting the battery. Stand at least 1 meter away.
-
Disconnect the battery ground wire with the ignition switched on.
-
ALWAYS perform an output diagnostic test under "Guided Functions " after repairing the rollover protection and only after all work procedures
are completed (also if a new rollover protection was installed).