R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Power Seat Switch: Service and Repair
Seat Adjustment Switch
Seat Adjustment Switch
‹› Removal and installation is the same on the driver and passenger seat.
Removal
-
Remove tunnel side trim panel. Refer to => [ Sill Side Trim ]. See: Service and Repair/Removal and Replacement/Power Seats/Sill Side Trim
-
Disconnect the electrical connectors - 6 - and - 7 -.
-
Remove seat and backrest adjustment actuators - 4 - and - 5 -. Refer to => [ Seat and Backrest Adjustment Actuator Assembly Overview ] See:
Description and Operation/Power Seats.
-
Remove the bolts - 1 -.
-
Remove the seat fore/aft, inclination, height and backrest adjustment switches - 2 -.
Installation
To install, perform the steps used in removal in reverse order.
Tightening specifications, refer to => [ Seat Adjustment Switch Assembly Overview ] See: Description and Operation/Power Seats.