R8 Quattro Coupe V10-5.2L (BUJ) (2010)
/Page-2540002.png)
-
Remove the backrest stop switch - 2 - with the wire and coupling from the housing.
‹› The two stop switches in the housing must not be separated and can only be replaced together with wire and coupling.
Installation
Installation is reverse of removal, but note the following:
CAUTION!
‹› Follow the safety precautions for pyrotechnic components.
‹› Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge
static electricity ". For example, by briefly touching the door striker pin.
‹› Ensure that electrical connections are pushed in as far as stop and engage with a click.
-
Switch on ignition.
CAUTION!
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not
repaired correctly. Individuals must not be inside the vehicle when connecting the battery.
-
Disconnect the battery ground wire with the ignition switched on.
‹› If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.
