R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Operate clutch pedal several times.
All Vehicles
-
Remove caps from the bleed screws.
-
Connect extractor bleed hose - 1 - to front left bleed screw, open bleed screw and allow about 200 ml to flow out. Close bleeder screw.
-
Repeat procedure on opposite front.
-
Connect extractor bleed hose - 1 - to rear left bleed screw, open bleed screw and allow about 200 ml to flow out. Close bleeder screw.
-
Repeat procedure on opposite rear.
Sequence and Brake Fluid Capacity Table
** Including brake fluid extracted from brake fluid reservoir and quantity from clutch slave cylinder.
-
Install the caps on brake caliper bleed screws.
-
Move filler lever on (VAS 5234) or (V.A.G 1869) to position - B - (see operating instructions).
-
Remove the filler hose from the adapter.
-
Remove the adapter from the brake fluid reservoir.
-
Check brake fluid level and fill if necessary.