R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Brake Caliper: Overhaul
Front Brake Caliper Piston, With Ceramic Brakes
Front Brake Caliper Piston, with Ceramic Brakes
Special tools, testers and auxiliary items required
‹› Trim Removal Wedge (3409)
‹› Piston resetting tool (T10145)
‹› Lithium grease (G 052 150 A2)
Removing
-
Remove brake pads. Refer to => [ Brake Pads ] See: Service and Repair/Front Brakes, With Ceramic Brakes PR-1LW.
-
Remove brake caliper. Refer to => [ Brake Caliper ] See: Service and Repair/Front Brakes, With Ceramic Brakes PR-1LW.
-
Brake caliper, removing and installing, refer to => [ Brake Caliper, Replacing ] See: Service and Repair/Front Brakes, With Ceramic Brakes
PR-1LW.
-
Force piston from brake caliper housing, one at a time, using compressed air.
Only one piston can be pressed out at a time. Secure opposite piston in brake caliper housing using piston resetting tool - a -. Block the other pistons,
e.g. using wood blocks - b -. In addition, place a wooden board - c - in front of the piston resetting tool so that the piston will not be damaged when
pressed out.
-
Remove seal with (3409).