R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Brake Caliper: Removal and Replacement
Brake Caliper, Replacing
Brake Caliper, Replacing
Special tools, testers and auxiliary items required
‹› Brake pedal actuator (V.A.G 1869/2)
Removing
-
Insert the (V.A.G 1869/2) between the brake pedal and driver seat by pressing the brake pedal down at least 60 mm.
-
Raise vehicle.
-
Remove wheels.
-
Connect the hose from a bleeder bottle to one of the bleeder screws on the rear caliper.
-
Open a bleeder screw on the rear brake caliper to reduce the pressure from the brake system.
-
Close the bleeder screw.
‹› Do not remove (V.A.G 1869/2).
-
Remove brake pads. Refer to => [ Brake Pads ]. See: Service and Repair/Rear Brakes, With Steel Brakes/Brake Pads
-
Remove the brake hose - 5 - from the brake caliper.
-
Remove the brake line bracket - 7 - from the brake caliper - 6 -.
-
Remove the bolts - 9 - while holding the brake caliper in place.
Installing
‹› Replace the bolts - 9 -.