R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Brake Caliper: Overhaul
Rear Brake Caliper Piston, With Ceramic Brakes
Rear Brake Caliper Piston, with Ceramic Brakes
Special tools, testers and auxiliary items required
‹› Trim Removal Wedge (3409)
‹› Piston resetting tool (T10145)
Removing
-
Raise vehicle.
-
Remove wheels.
-
Remove the brake pads on the rear ceramic brakes. Refer to => [ Rear Brake Pads ] See: Disc Brake System/Service and Repair/Rear Brakes,
With Ceramic Brakes.
-
Remove the brake caliper on the rear ceramic brakes. Refer to => [ Brake Caliper ] See: Disc Brake System/Service and Repair/Rear Brakes, With
Ceramic Brakes.
-
Replace the brake caliper on the rear ceramic brakes. Refer to => [ Brake Caliper, Replacing ] See: Disc Brake System/Service and Repair/Rear
Brakes, With Ceramic Brakes.
CAUTION!
Do not perform any repair work on the brake caliper except for removing and installing the pistons.
-
Force piston from brake caliper housing, one at a time, using compressed air.
Only one piston can be pressed out at a time. Secure opposite piston in brake caliper housing using piston resetting tool - a -. Block the other pistons,
e.g. using wood blocks - b -. In addition, place a wooden board - c - in front of piston resetting tool so that the piston will be not be damaged when
pressed out.
-
Remove seal with (3409).