R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Install the new bolts - 3 - in the brake caliper and tighten them: 110 Nm.
-
Install the brake hose into the brake caliper.
‹› Brake hose in brake caliper: 16 Nm.
‹› Brake pressure line to brake hose: 16 Nm.
‹› Make sure the brake hose is not twisted.
-
Attach the brake hose bracket - 13 - with the bolt - 14 -: 25 Nm.
‹› Brake hose bracket to brake caliper: 25 Nm
‹› Brake hose bracket to crossmember support and suspension: 9 Nm
-
Install brake pads. Refer to => [ Brake Pads ]. See: Disc Brake System/Service and Repair/Front Brakes, With Ceramic Brakes PR-1LW/Brake
Pads
-
Bleed brake system. Refer to => [ Brake System, Bleeding ] See: Brake Bleeding/Service and Repair/Brake System, Bleeding
-
Install wheels.
-
Check brake fluid level, and fill if necessary.
CAUTION!
After the first drive, depress brake pedal firmly several times with vehicle stationary so that the brake pads are properly seated in their
normal operating position.
CAUTION!