R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Remove the speed sensor - 1 - from the wheel bearing housing.
Installing
Installation is the reverse of removal, with special attention to the following:
-
Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with Polycarbamide grease G 000 650.
-
Install the brake caliper. Refer to => [ Brake Caliper ] See: Disc Brake System/Service and Repair/Front Brakes, With Steel Brakes.
-
Turn the steering completely left and right, making sure that the speed sensor wiring has sufficient clearance.
-
Install the wheels.
-
Lower the vehicle.