R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Checking voltage
-
Switch the ignition on.
-
Using a Multimeter, Check the Camshaft Adjustment Valve 1 (N205) electrical harness connector terminal 2 to Ground (GND) for voltage.
Specified value: battery voltage.
-
Switch the ignition off.
If the specified value was not obtained:
-
Check the wiring connection from the Camshaft Adjustment Valve 1 (N205) electrical harness connector terminal 2 to the Motronic Engine
Control Module (ECM) Power Supply Relay (J271) socket 2/87 for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used, perform the following step.
-
Install the test box. Refer to appropriate repair information.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to appropriate repair information.
-
Using a Multimeter, check the Camshaft Adjustment Valve 1 (N205) electrical harness connector terminal 2 to the Motronic Engine Control
Module (ECM) (J623) electrical harness connector T60/45 for an open circuit.
Specified value: 1.5 ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.