R8 Quattro Coupe V10-5.2L (BUJ) (2010)
‹› Replacing, refer to => [ Crankshaft Shaft Seal, Belt Pulley Side, Replacing ] See: Seals and Gaskets/Front Crankshaft Seal/Service and Repair.
5
Crankshaft
‹› Measuring axial play, refer to => [ Crankshaft, Measuring Axial Play ] See: Testing and Inspection/Crankshaft, Measuring Axial Play
‹› Radial clearance, measuring, refer to => [ Crankshaft, Measuring Radial Play ] See: Testing and Inspection/Crankshaft, Measuring Radial Play
‹› Crankshaft dimensions, refer to => [ Crankshaft Dimensions ] See: Specifications
6
Bearing Bracket
‹› Paired to - 1 -
‹› Sealant application on the guide frame - suction module side
‹› Tightening order
7
Gasket
‹› Replace
8
O-ring
‹› Replace
9
Alignment Bushing
‹› Installing into the guide frame, suction module side
‹› Installed location
10
Bolt
‹› 9 Nm
11
Flange to Protection Tube
‹› Install with sealant
‹› Sealant application
12
Suction Module
13
Bolt
‹› For the sealing surfaces, suction module to guide frame
‹› Tightening specification and sequence
14
Bolts
‹› Replace
‹› Different lengths
‹› Tightening specification and sequence
15
Seal
‹› Replace
16
Plug
‹› 45 Nm