R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Oil Cooler: Service and Repair
Engine Oil Cooler Thermostat
Engine Oil Cooler Thermostat
Special tools, testers and auxiliary items required
‹› Engine Bung Set (VAS 6122)
Removing
-
Remove the left engine oil cooler. Refer to => [ Left Engine Oil Cooler ] See: Left Engine Oil Cooler.
-
Remove bolts - 1 - and - 4 -.
-
Push the engine oil cooler thermostat - 3 - downward - arrow B -.
-
Turn the oil pipe - 2 - 180° - arrow A - and remove it and the thermostat from the engine oil cooler.
-
Seal the open lines and connections with clean plugs from the (VAS 6122).
Installing
‹› Tightening specifications, refer to => [ Oil Tank Assembly Overview ] See: Oil Reservoir/Service and Repair/Oil Tank Assembly Overview.
Installation is in reverse order of removal, note the following:
‹› Replace O-rings.
-
Clean the sealing surfaces.
-
Install the left engine oil cooler. Refer to => [ Left Engine Oil Cooler ] See: Left Engine Oil Cooler.