R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Remove bolts - 1 -.
-
Remove the bolts - 4 - and remove the oil return line - 3 - from the oil tank.
-
Disconnect electrical connector - 5 - on oil level thermal sensor (G266).
-
Remove the bolts - 1 - and - 2 - and the oil tank.
‹› The bolt is reached - 2 - from the left wheel housing side.
-
Seal the open lines and connections with clean plugs from the (VAS 6122).
Installing
‹› Tightening specifications, refer to => [ Oil Tank Assembly Overview ] See: Oil Tank Assembly Overview.
Installation is in reverse order of removal, note the following:
‹› Replace O-rings.
-
Install the stabilizer bar. Refer to => [ Muffler ] See: Exhaust System/Muffler/Service and Repair/Muffler.
-
Fill the engine oil and then check the level.