R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Run the hand vacuum pump to generate a vacuum.
‹› The intake flaps are opened.
-
Press the intake manifold lower section and fuel rail evenly onto the fuel injectors.
-
Remove the (VAS 6213) vacuum hose from the intake manifold runner control vacuum actuator.
-
Install the high pressure line. Refer to => [ High Pressure Line ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Supply
Line/Service and Repair.
-
Install the upper section of the intake manifold. Refer to => [ Intake Manifold, Upper Section ] See: Intake Manifold, Upper Section.
‹› Check the vacuum system for leaks. Refer to => [ Vacuum System, Checking ] See: Powertrain Management/Fuel Delivery and Air
Induction/Testing and Inspection/Component Tests and General Diagnostics/Vacuum System, Checking.