R8 Quattro Coupe V10-5.2L (BUJ) (2010)
/Page-570005.png)
-
Clean the sealing surfaces; they must be free of oil and grease.
-
Clean the old sealant off the holes - arrow - in the cylinder head gasket.
‹› With cylinder head installed, holes in cylinder head seal are only half visible.
CAUTION!
The cylinder head seal could be damaged.
‹› Only bend ends of cylinder head seals slightly, do not kink.
‹› A kinked cylinder head seal must be replaced.
-
Bend the end of the cylinder head seals down slightly - arrows - until the upper sealing surface of the seals and the cylinder head can be cleaned.
-
Clean the upper and lower cylinder head gaskets; they must free from oil and grease.
‹› Note the expiration date of the sealing compound.
