R8 Quattro Coupe V10-5.2L (BUJ) (2010)
The rest of the installation is in reverse order of removal, note the following:
-
Install the transmission-side crankshaft shaft seal. Refer to => [ Crankshaft Seal, Transmission Side ] See: Seals and Gaskets/Crankshaft Main
Bearing Seal/Service and Repair.
-
Install the timing chain covers. Refer to => [ Left Timing Chain Cover ] See: Left Timing Chain Cover, or => [ Right Timing Chain Cover ] See:
Right Timing Chain Cover for the right.
-
Install the studs with a commercially available stud extractor until dimension - a - is reached.
‹› Dimension - a - = 35 ± 1 mm.
-
Install the oil filter housing. Refer to => [ Oil Filter Housing ] See: Engine Lubrication/Oil Cooler/Service and Repair/Oil Filter Housing.
-
Install the upper section of the intake manifold.
-
Install the drive-through shaft.