R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Air Door Actuator / Motor: Service and Repair
Air Flow Door Motor With Position Sensor
Air Flow Door Motor with Position Sensor
Special tools, testers and auxiliary items required
‹› Release Tool (T40072)
‹› If the malfunction "Upper or lower threshold exceeded" is present, check the motor/door connecting piece. It must be installed on the correct side
of the motor and there must not be any play between the control motor mount and the connecting piece.
‹› Various identical electrical connectors are installed in the air intake unit. mark the electrical connectors before disconnecting them (they could
become mixed up).
‹› Various control motors are installed on the A/C unit and in the air intake unit. They have different electrical values and are different in the part
number index. Mark the control motors before removing them (so they are not switched).
Removing
-
Switch off ignition.
-
Remove the air intake unit, refer to => [ Air Intake Unit ] See: Air Duct/Service and Repair/Air Intake Unit.
-
Remove the air intake unit upper cover, refer to => [ Air Intake Unit Upper Cover ] See: Air Duct/Service and Repair/Air Intake Unit Upper Cover
.
-
Remove bolts - A -.
-
Disconnect the electrical connector - B - on the Air Flow Door Motor (V71) - C -.
-
Remove the air flow door motor.
-
If the connecting piece - B - will be removed, insert the (T40072) - A - in the piece.