R8 Quattro Coupe V10-5.2L (BUJ) (2010)
4
Recirculation Door Motor (V113)
‹› With the Recirculation Door Motor Position Sensor (G143).
‹› Removing and installing, refer to => [ Recirculation Door Motor ] See: Air Door/Air Door Actuator / Motor/Service and Repair.
5
Screw
‹› Tightening specification 1 Nm.
6
Screw
‹› Tightening specification 1 Nm.
7
Fresh Air Blower Control Module (J126)
‹› Check using Vehicle diagnosis, testing and information system VAS 5051/ in the "Guided Fault Finding" function.
‹› Removing and installing, refer to => [ Fresh Air Blower Control Module ] See: Control Module HVAC/Service and Repair/Fresh Air Blower
Control Module.
8
Lever
9
Air Intake Unit Upper Cover
‹› Removing and installing, refer to => [ Air Intake Unit Upper Cover ] See: Air Intake Unit Upper Cover.
10
Water Drain Channel
‹› Removing and installing, refer to => [ Air Intake Unit Upper Cover ] See: Air Intake Unit Upper Cover.
11
Screw
‹› Tightening specification 1 Nm.
12
Screw
‹› Tightening specification 1 Nm.
13
Water Channel
‹› Removing and installing, refer to => [ Air Intake Unit Upper Cover ] See: Air Intake Unit Upper Cover.
14
Fresh Air Blower (V2)
CAUTION!
Do not hold the fresh air blower (V2) fan wheel. Putting pressure on the fan wheel or sliding the balancing weight on it can cause an
imbalance and lead to problems during operation.
‹› Check using Vehicle diagnosis, testing and information system VAS 5051/ in the "Guided Fault Finding" function.
‹› Removing and installing, refer to => [ Fresh Air Blower ] See: Blower Motor/Service and Repair.
15
Screw
‹› Tightening specification 1 Nm.
16
Screw
‹› Tightening specification 1 Nm.
17
Air Flow Door Motor (V71)
‹› With the Back Pressure Door Motor Position Sensor (G113)