R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Insert the reservoir - A - in the bracket - G -.
-
Attach refrigerant lines, refer to => [ Refrigerant Lines, Disconnecting from Condenser and Connecting ].
-
When tightening the bolts - B -, hold the reservoir so the refrigerant lines - E and F - are free of tension.
-
Tighten the bolts - C and D -.
‹› Tightening specification: 9 Nm.
-
Install the left rear wheel housing liner.
-
Evacuate and fill refrigerant circuit.
After finishing the repairs, perform the following work on the Climatronic Control Module (J255) using the Vehicle diagnosis, testing and information
system VAS 5051/ in the "Guided Fault Finding" function:
-
Check the DTC memory and erase any malfunctions shown.
-
Operate the A/C system after filling the refrigerant circuit, refer to => [ Operating After Filling Refrigerant Circuit ] See: Service
Precautions/Technician Safety Information/Heating, Ventilation & Air Conditioning.
‹› Note the information regarding operating the A/C system after filling.