R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Fuel Gauge Sender: Service and Repair
Fuel Level Sensor 2
Fuel Level Sensor 2
Removing
-
Observe safety precautions. Refer to => [ Safety Precautions ] See: Powertrain Management/Fuel Delivery and Air Induction/Service
Precautions/Vehicle Damage Warnings/Safety Precautions.
-
Observe rules for cleanliness. Refer to => [ Clean Working Conditions ] See: Powertrain Management/Fuel Delivery and Air Induction/Service
Precautions/Vehicle Damage Warnings/Clean Working Conditions.
‹› During installation, all cable ties must be installed at the same location.
-
Remove the fuel delivery unit. Refer to => [ Fuel Delivery Unit ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Pump/Service and Repair/Fuel Delivery Unit.
-
Reach into the fuel tank and remove the fuel level sensor 2 by pressing locking tabs at the same time - 1 - and - 2 - out of the baffle house guide -
arrow -.
‹› Fuel level sensor 2 is illustrated without the fuel tank.
-
Guide the fuel level sensor 2 carefully to the fuel tank opening and disconnect the electrical connector - 1 -.