R8 Quattro Coupe V10-5.2L (BUJ) (2010)
‹› Sensor at the lower stop: approximately 994 ohms.
‹› Sensor at the upper stop: approximately 57.1 ohms.
‹› If measured value is 0 ohms there is a short circuit. If measured value is infinite ohms there is and open circuit in the wiring.
Assembly is in reverse order of removal, note the following:
‹› Tightening specifications, refer to => [ Fuel Level Sensor Assembly Overview ] See: Service and Repair/Fuel Level Sensor Assembly Overview,
=> [ Locking Flange Cover - Tightening
Specifications ] See: Service and Repair/Fuel Level Sensor Assembly Overview.
-
Inspect the seal - 1 - on the locking flange covers for damage.
-
If necessary, replace the seal.
-
Install the connector station and the right rear relay and fuse panel.
R8 Spyder
-
Install the cover module.
All Vehicles
-
Connect the battery and observe safety precautions after connecting battery.