R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Take the yellow repair wire with the correct contact out of the wiring harness repair set (VAS 1978 B).
-
Free up the wire to be repaired approximately 20 cm on both sides of the repair point.
CAUTION!
Risk of damaging the electrical wires.
‹› Expose wrapped wiring harnesses carefully.
-
If necessary, removing the wiring harness wrapping using a knife.
-
Slide the new repair wire contact into the corresponding connector housing compartment until it engages.
-
If necessary, install the single wire seal on the repair wire.
-
Shorten the repair wire and the vehicle specific wiring harness single wire as needed using the (VAS 1978/3).