R8 Quattro Coupe V10-5.2L (BUJ) (2010)
If the manufacturers test box is being used, perform the following step.
-
Install the test box. Refer to appropriate repair information.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to appropriate repair information.
-
Using a Multimeter, Check the Camshaft Position (CMP) Sensor (G40) electrical harness connector to the Motronic Engine Control Module
(ECM) (J623) electrical harness connector T60a for an open circuit.
Specified value: 1.5 ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring and voltage supply was OK:
-
Replace the Camshaft Position (CMP) Sensor (G40). Refer to appropriate repair information.
If no malfunction is found in the wiring and voltage supply was not OK:
-
Replace the Motronic Engine Control Module (ECM) (J623). Refer to appropriate repair information.
-
Assembly is performed in the reverse order of removal.
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 0A.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing