R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Disconnect the electrical connectors - 3 - on the connector station and remove the connector station from the control module bracket and lay it to
the side.
-
Remove the right rear relay and fuse carrier from the control module bracket and lay it aside - arrows -.
‹› Ignore - 1, 2 and 5 -.
-
Disconnect the control module electrical connectors and remove the control module bracket - arrow - from the vehicle.
-
Press the electrical wiring harness off the rear bulkhead using (80 - 200) and free it up.
R8 Spyder
-
Remove the cover module.
All Vehicles
-
Fold the insulation mat over the connection seal cover.
-
Remove bolts - 1 through 4 - and remove the left locking flange cover.