R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Air Flow Meter/Sensor: Service and Repair
Mass Air Flow Sensors
Removing
‹› The following procedure describes removal and installation of the left mass air flow sensor 2 (G246).
-
Install the protective body covers. Refer to => [ Protective Body Covers, Installing ] See: Service and Repair/Procedures.
-
Remove the engine cover - arrows -. Do not jerk or pull to one side.
-
Disconnect the connector - 1 -.
-
Remove the mass air flow sensor from the air filter element - arrows -.
Installing
Installation is in reverse order of removal, note the following:
‹› Tightening specifications, refer to => [ Air Filter Assembly Overview ] See: Air Cleaner Housing/Service and Repair/Air Filter Assembly
Overview.
‹› To ensure both mass air flow sensors work correctly, follow the information and procedure below.=> [ To ensure both mass air flow sensors work
correctly, follow the information and procedure below. ] See: Air Cleaner Housing/Service and Repair/Air Filter