R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Using the scan tool, check the throttle valve position (absolute) at Wide Open Throttle (WOT):
-
End diagnosis and switch ignition off.
If the specified values are not obtained:
Test Procedure
-
Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] See: Computers and Control Systems/Testing
and Inspection/Scan Tool Testing and Procedures/Preliminary Check
-
Remove the rear engine cover - 2 -.
-
Disconnect the Throttle Valve Control Module 2 (J544) electrical harness connector - arrow -.