R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Check the electrical harness connector for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace the Throttle Position (TP) Sensor (G79)/Accelerator Pedal Position Sensor 2 (G185). Refer to appropriate repair information.
If no malfunction is detected in the wiring and if the voltage supply was not OK:
-
Replace the Motronic Engine Control Module (ECM) (J623). Refer to appropriate repair information.
Assembly is performed in the reverse order of removal.
-
Install the drivers side storage compartment. Refer to appropriate repair information.
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 0A.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 0A.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.