R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Checking internal resistance
-
Using a multimeter, check the Throttle Drive (for Electronic Power Control (EPC)) (G186) at the Throttle Valve Control Module 2 (J544)
terminals 3 to 5 for resistance.
Specified value: 1.0 to 5.0 ohms (at 20 °C)
If the specified value was not obtained:
-
Replace the Throttle Valve Control Module 2 (J544). Refer to appropriate repair information.
If the specified value was obtained:
Checking voltage
-
Using a Multimeter, check the Throttle Valve Control Module 2 (J544) electrical harness connector terminals 2 to 6 for voltage.