R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Suspension Control Module: Service and Repair
Electronic Damping Control Module
Special tools, testers and auxiliary items required
‹› Vehicle Diagnostic, Testing and Information System (VAS 5051B)
Removing
The electronic damping control module (J250) is behind the rear shelf (coupe) or bulkhead trim (Spyder) on the right vehicle side.
-
Remove the rear shelf in the coupe.
-
Remove the right bulkhead trim in the Spyder.
-
Remove bolts - 1 -.
-
Remove nuts - 2 -.
-
Disconnect the connector - 2 - and remove the control module - 1 - to the side.
Installing
Installation is the reverse of removal, with special attention to the following:
-
Install the rear shelf or bulkhead trim.