R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Control Module: Service and Repair
Transmission Control Module
Transmission Control Module
Removing
-
Remove the rear shelf.
-
Disconnect electrical connectors - 1 - and - 2 - on the Transmission Control Module (J217).
-
Remove the nuts - arrows - and the Transmission Control Module (J217).
Installing
Install in reverse order, paying attention to the following:
-
Install the rear shelf.
If "update programming" was performed on the Transmission Control Module (J217) or the module was replaced:
-
Perform clutch basic setting. Refer to => [ Clutch Basic Setting, R Tronic ] See: Transmission and Drivetrain/Clutch/Testing and
Inspection/Programming and Relearning.
-
Perform gear selector basic setting. Refer to => [ Gear Selector Basic Setting ] See: Transmission and Drivetrain/Manual
Transmission/Transaxle/Gearshift Actuating System - M/T/Testing and Inspection.
Tightening Specifications