R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Power Seat Switch: Service and Repair
Manual Seats
Lumbar Support Adjustment Switch
‹› Removal and installation is the same on the driver and passenger seat.
Removal
-
Remove tunnel side trim panel. Refer to => [ Sill Side Trim ]. See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Manual
Seats/Sill Side Trim
-
Disconnect electrical harness connector - 4 -.
-
Remove the bolts - 3 -.
-
Remove lumbar support adjustment switch - 1 - from trim panel - 2 -.
Installation
To install, perform the steps used in removal in reverse order.
Tightening specifications, refer to => [ Lumbar Support Adjustment Switch Assembly Overview ] See: Body and Frame/Seats/Description
and Operation/Manual Seats.