R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Oil Level Sensor: Service and Repair
Oil Level Thermal Sensor
Removing
-
Install protective body covers. Refer to => [ Protective Body Covers, Installing ] See: Engine, Cooling and Exhaust/Engine/Service and
Repair/Procedures.
-
Remove the air filter housing.
-
Disconnect the connector - 2 -.
-
Remove the bolts - arrows - and then remove the oil level thermal sensor (G266)- 1 - from the oil tank.
Installing
‹› Tightening specifications, refer to => [ Oil Tank Assembly Overview ] See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Oil
Reservoir/Service and Repair/Oil Tank Assembly Overview.
Installation is in reverse order of removal, note the following:
‹› Replace O-ring.
-
Install air filter housing.