R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Installing
To installed, perform the steps done during removal in reverse order. Note the following:
-
Replace the seal - B - if it is damaged or faulty.
-
When inserting, make sure the wide guide - D - on the left vent temperature sensor - A - aligns with the mount - C - on the A/C unit.
-
Install the footwell vent air channel, refer to => [ Left Front Footwell Vent ] See: Heating and Air Conditioning/Air Register/Service and Repair.
-
Install the center console left side trim.
-
Install the driver side instrument panel cover.
After finishing the repairs, perform the following work on the Climatronic Control Module (J255) using Vehicle diagnosis, testing and information
system VAS 5051/ in the "Guided Fault Finding" function:
-
Check the DTC memory and erase any malfunctions shown.
Right Vent Temperature Sensor
Removing
-
Switch off ignition.
-
Remove the glove compartment.