R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensors
Removing
‹› The following procedure describes removal and installation on the left cylinder bank 2.
‹› During installation, re-install all heat insulation sleeves at the same locations.
Camshaft Position Sensor, Exhaust Camshaft
‹› Engine removed.
-
Remove the exhaust manifold.
-
Remove the bolts - arrows - and the heat shield - 1 -.
-
Remove the heat shield boot.
-
Disconnect the connector - 2 -.
-
Remove the bolt - 1 - and the camshaft position sensor.
Camshaft Position Sensor, Intake Camshaft
-
Install the protective body covers. Refer to => [ Protective Body Covers, Installing ] See: Powertrain Management/Fuel Delivery and Air