R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Repair the malfunction and repeat the test sequence.
If the electrical harness connector is OK:
-
Check the wiring according to the wiring diagram:
If no malfunctions are found in the wiring:
-
Replace the Mechatronic unit in the transmission. Refer to appropriate repair information.
Final procedures
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 0A.
2. If necessary, erase the Transmission Control Module (TCM) (J217) memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See:
Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 0A.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.