R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Lubricate the O-ring - 2 - on the Gear Recognition Sensor (G604) lightly.
-
Position the Gear Recognition Sensor (G604) - 1 - in the "9:00 position" on the R tronic shift actuator bolting eyelet - arrow A - as shown in the
illustration.
‹› The actuating pin - 3 - fits into the bracket on the Gear Recognition Sensor (G604).
-
When pressing on the Gear Recognition Sensor (G604), make sure the O-ring is not crushed.
-
Turn the Gear Recognition Sensor (G604) clockwise - arrow B - so the bolts can be installed.
‹› When turning, the sensor spring force becomes noticeable.
-
Install the bolts.
Further installation in reverse order, paying attention to the following:
-
Install the air filter housing.
-
Install the engine compartment trim.
-
Install the rear bumper cover.
-
Perform gear selector basic setting. Refer to => [ Gear Selector Basic Setting ] See: Transmission and Drivetrain/Manual
Transmission/Transaxle/Gearshift Actuating System - M/T/Testing and Inspection.