R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Alternator: Service and Repair
Generator
Generator
Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] See: Battery/Service Precautions/Vehicle Damage Warnings.
Removing
-
With ignition switched off, disconnect battery ground wire. Refer to => [ Battery, Disconnecting and Connecting ] See: Tools and
Equipment/Battery, Disconnecting and Connecting.
-
Remove the ribbed belt from the generator belt pulley.
-
Drain the coolant.
-
Disconnect electrical connector - 5 -.
-
Removed the cap - 1 - and the nut.
-
Disconnect the B+ wire.
-
Remove the bolt - 4 - and remove the bracket - 3 -.
-
Disconnect the coolant lines - 2 - from the generator.
‹› For a better overview, the installation location is shown with the engine removed.