R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Release secondary latch - 6 - (blue pin) using a small screwdriver - arrow -.
-
Release catch - 2 - and remove fiber optic cable - 5 - with brass connector pin - 4 - from base module - 1 -.
Installing
Install in reverse order of removal, observing the following:
-
Install fiber optic cable in line with markings.
‹› Seal open harness connector - 2 - for fiber optic cable using protective cap for cable connector (VAS 6223/9) - item 1 -.
‹› Protective cap prevents contamination of or mechanical damage to end face of fiber optic cable which would impair signal transmission.