R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Wiring Harness: Procedures
Primary Connector, With Round Connector Systems
Primary Connector, with Round Connector Systems
Procedure
‹› If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts.
-
Guide the release tool which fits the connector housing into release channel on connector housing.
-
Grasp the contact at the wire and gently push it into the connector housing - left arrow -.
‹› By pushing the contact in the direction of the connector housing, contact retaining tabs are lifted off the housing shoulder and can be released
using the release tool.
-
At the same time, push the release tool in the direction of the connector housing - right arrow - and pull the released contact out of the connector
housing.
-
Remove the release tool after removing the contact from the housing.