R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Disconnect the connector - 5 -.
-
Unclip the electric wire - 4 -.
-
Remove the ball studs - 1 -.
-
Remove bolt - 3 -.
-
Remove level control system sensor - 2 -.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
Sensor lever must point outward.
Tightening specifications, refer to => [ Lower Transverse Link with Retaining Bracket, Stabilizer Bar, Coupling Rod and Level Control System
Sensor Assembly Overview ] See: Suspension/Control Arm/Service and Repair/Front Suspension/Lower Transverse Link With Retaining Bracket,
Stabilizer Bar, Coupling Rod and Level Control System Sensor Assembly Overview.
-
Readapt control position using the (VAS 5051B).