R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Disconnect the connector - 2 -.
-
Remove the ball studs - 4 -.
-
Remove bolts - 3 -.
-
Remove level control system sensor - 1 -.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
Sensor lever must point outward.
Tightening specifications, refer to => [ Upper Transverse Link with Retaining Bracket and Vehicle Level Control System Sensor Assembly Overview
] See: Suspension/Control Arm/Service and Repair/Rear Suspension/Upper Transverse Link With Retaining Bracket and Vehicle Level Control
System Sensor Assembly Overview
-
Readapt control position using the (VAS 5051B).
-
Perform headlamp basic setting.