R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
At steering column electronic systems control module, slide a dia. 2.5 mm drill - item 2 - approximately 45 mm into the hole - arrow 1 -,
releasing the retaining detent - arrow 2 -.
-
Pull steering column electronic systems control module down slightly and remove drill.
-
Release retaining clip - arrow - on connector side of steering column electronic systems control module and remove control module from steering
column switch module.
Installing
‹› Tightening specification, refer to => [ Steering Column Switch Module Assembly Overview ] See: Steering Mounted Controls Communication
Module/Service and Repair.
Install in reverse order of removal, observing the following:
-
Install steering column trim.
-
Install steering wheel.
-
Install airbag unit.