R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Rear Cross-Member: Service and Repair
Rear Suspension
Tie Rod
Special tools, testers and auxiliary items required
‹› Ball joint puller (3287 A)
‹› Torque wrench (V.A.G 1331)
‹› Torque wrench (V.A.G 1332)
Removing
-
Determine dimension - a - from the center of the wheel to the lower edge of the wheel housing before starting work while the vehicle is resting on
its wheels.
-
Remove wheel.
-
Remove air guides - 1 - and noise insulation - 2 -.
-
Mark the eccentric washer - 6 - to retaining bracket - 3 - and the eccentric washer - 1 - to retaining bracket - 7 -, e.g. with a felt tip pen.