R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Installation is performed in the reverse order of removal. Observe the following when doing so:
‹› Bonded rubber bearings can only be turned to a limited extent. Only tighten suspension bolts when vehicle is in curb weight or control position.
-
Insert the bolt - 2 - and install the nut - 1 - loosely.
-
On vehicles with electronically-controlled damping (Audi magnetic ride), connect the connector - 3 - to the suspension strut - 4 -.
-
Insert the bolt - 3 - and pre-tighten the nut - 1 - to 8 Nm.
-
Tighten the nut - 1 -.