R8 Quattro Coupe V10-5.2L (BUJ) (2010)
‹› Use a commercially available separating tool, e.g. (Kukko 17/2).
This deforms slide washer and it must be replaced.
-
Remove the bearing inner race from the 85 mm diameter wheel bearing and from the wheel hub.
A Separating tool, 22 to 115 mm, e.g. (Kukko 17/2)
Replacing the Slide Washer, 85 mm Diameter Wheel Bearings
-
Carefully pry out old slide washer - 1 - with a screwdriver.
-
Position new slide washer on wheel hub.
-
Install special tools as shown in illustration.