R8 Quattro Coupe V10-5.2L (BUJ) (2010)
/Page-1120008.png)
-
Insert bolts - 3 through 8 - with sealant (AMV 174 004 01) and tighten by hand.
-
Tighten the bolts to the specification in the sequence - 1 through 8 -.
Further installation is in reverse order, paying attention to the following:
-
Check the oil level in the R tronic hydraulic unit and fill. Refer to => [ Oil Level in R Tronic Hydraulic Unit ] See: Manual
Transmission/Transaxle/Gearshift Actuating System - M/T/Manual Trans Hydraulic Fluid/Description and Operation.
-
Install the rear bumper cover.
-
Install the rear wheel housing liners and front noise insulation.
-
Install the air filter housing.
-
Install the engine compartment trim.
-
Perform gear selector basic setting. Refer to => [ Gear Selector Basic Setting ] See: Manual Transmission/Transaxle/Gearshift Actuating System -
M/T/Testing and Inspection.
